6 Steps To Change A Code On A Keypad Door Lock

Did you forget the code of your door lock or someone knows the code? If that’s the case, you’ll need to change the code instantly. Most keypad door locks come with a factory default code that is easy to remember. However, it is always advisable to change the code to something that only you know. This will increase the security of your home or office. This article will show you some effortless steps to change a code on a keypad door lock.

1. Make sure that the door is open and unlocked

Before starting

1: Locate the code change button on the lock. It is usually a small button near the keypad. 

2: Press and hold the code change button for a few seconds.

3: Enter your new code twice. The first time you will enter it as a confirmation.

4: Test the new code to make sure it works.

5: Close and lock the door.

2. Enter the programming code

This is usually the factory default code, which can be found in the instruction manual.

1: Press the * button.

2: Enter the new code that you want to use.

3: Press the # button.

4: Test the new code to make sure it works.

5: Close and lock the door.

6: Change the batteries if necessary. Most keypad locks use AA or AAA batteries

3. Press the lock button

1: Enter the new code that you want to use.

2: Press the lock button again to exit programming mode.

3: Test the new code to make sure it works.

4: Close and lock the door.

4. Press the “3” button three times

1: Enter the new code that you want to use.

2: Press the “3” button again to exit programming mode.

3: Test the new code to make sure it works.

5: Close and lock the door.

5. Enter the access code you want to change

, then press the “C” button.

1: Enter the new code that you want to use.

2: Press the “C” button again to save the new code.

3: Test the new code to make sure it works.

4: Close and lock the door.

6. Press and hold the “0” button for three seconds. This will put the lock into programming mode. 

1: Enter the new code that you want to use.

2: Press the “0” button again for three seconds to exit programming mode.

3: Test the new code to make sure it works.

Read More: How to install a door lock set – Step-By-Step Guide | How To Lock Garage Door Manually | How to lock your door without a lock | How to unlock bathroom door twist lock | Best Smart Lock For Bedroom Door

Leave a Comment